Tifa Lockhart Cosplay Armor Set offers Inspired by Final Fantasy VII Remake

3D Printed Prop Kit of Tifa's Armor based on its appearance in the Final Fantasy VII Remake.

If you choose the "Kit" option, you will get all of the pieces you need to have a base for the armor. The kit includes:

- Forearm bracer
- Elbow guard
- Bicep armor
- Finger armor (x8)
- Two thumb armor pieces (x2)
- Back of hand armor
- Wrist cuff/Materia holder

The piece will come with two clear printed Materia pieces for the wrist cuff, however I highly recommend that you resin cast it for a better appearance. You can also finish them with XTC3D to retain the transparency.

For measurements:

- Forearm bracer has roughly a 7" length, keep in mind that the forearm/elbow are two pieces, so this only needs to go about 1/2-3/4 up your forearm from the wrist
- The elbow guard/upper forearm bracer is about a 7 inch length as well, but keep in mind this is supposed to sit off the elbow as it does in most references
- The bicep guard is a half-circle curve about 6" in length, going from mid-front bicep to mid-back bicep.
- The wrist Materia cuff has about a 7.5" circumference in the opening, keep in mind this is supposed to fit offers snuggly on your wrist, and comes in two shells with magnet holes for 10x2 mm magnets that can be purchased online, so you do not have to slide it over your hand to wear it

If you need these resized, larger or smaller, please order the Custom Measurements options, and send me a message after purchase. You will need to send the following measurements:

- Circumference of your wrist
- Diameter of your mid-forearm, and also length of 3/4 of your forearm
- Diameter of the top of your forearm (thickest part, near elbow)
- Half circumference of your bicep (middle of the front to middle of the back)

Buyer is solely responsible for sending accurate measurements.

Again, the "Kit" option is for a kit for the prop, so all you will receive is the printed pieces. You will have to assemble, prime, paint, and finish the prop yourself. The photos are an example of a set of armor that has been finished.

The wrist cuff has space for four (4) 10x2 mm magnets that can be purchased online. You will also need strapping for all of the bracer/elbow/bicep armor. Because of the nature of the armor, you may need to add velcro in places underneath to keep everything in line on your arm. Final Fantasy logic doesn't apply in real life, unfortunately.

Because of the nature of the back of the hand pieces, they are made with a slight curve. They are all printed with PLA plastic, which is a thermoplastic, so if they don't sit right on your hand/glove, they (and all other parts) can be treated with light heat and reshaped, but be careful not to overheat them.

If you choose the "Finished" option, you will receive fully primed, painted, and sealed armor pieces. They do NOT come with the belts, you will have to add those yourself so that they will fit your measurements precisely. These can also be molded with heat to fit better but be VERY careful as you can easily mess up the paint job and finishing this way!

If you have any other questions, just ask!